Replacement Insulated Glass Unit

Overall width and height can be up to a maximum overall dimension of 96 inches by 60 inches.

To accurately measure you will likely need to temporarily remove your existing window. Measure the outside dimensions (height and width) of the sealed window unit to the nearest 1/16”. Measure the dual pane overall thickness. This will typically be ½”, 5/8”, ¾”, 7/8” or 1”. You may attach a custom drawing, pattern or sketch or any special comments about your order.

Almost any possible shape. This includes: Square/Rectangle, Single Slope Rectangle, Circle, House, ArchArch-Top, Arch Top & Bottom, Arch Side, Rounded Corner(s), Clipped Corner(s), Pentagon, Hexagon, Octagon, Ellipse, Racetrack Oval, Quarter Round, Quarter Round with Notch, Half-Circle, Half-Circle with Notch, Trapezoid, Parallelogram, Right Triangle, Triangle, Quad Arch, Irregular/Any Other Shape.

½” to 1” thicknesses for the overall insulated unit. Please note, not all thicknesses may be available based on the overall size of the insulated unit. Larger windows are only available in larger thicknesses.

Yes, there is a 10 year limited warranty from the date of manufacture.

Aluminum, Champagne and Dark Bronze.

The following combination of glass tints are available: Clear / Clear, Low-E / Clear, Solex / Clear, Light Gray / Clear, Bronze / Clear, P516 / Clear, Bronze / Low-E, P516 / Low-E, Light Gray / Low-E, Solex / Low-E, Rain / Clear, Clear Tempered / Laminate, Dark Gray / Clear, Solar Cool Bronze / Clear, Satin Etch / Clear. Color examples are shown in the online pricing / order wizard to aid in your selection.

Low-E glass helps deliver year round comfort and energy savings. In the winter, it reflects heat back into the room. In the summer, it rejects the sun’s heat and UV rays.

Low-E Insulated units should be glazed with the Low-E facing on the outside, clear on the inside.

Yes, a tempering logo is a small etching that is made in one corner of each piece of glass indicating that it has been tempered and meets government standards for tempered glass. We can add our logo to any piece(s) in your order if your building department or project specifications require it. The default for us is to not logo the glass so you will need to specify on the Order Form if you wish to have us logo your glass.

Yes, options include ⅝” grid or a decorative 1” sculptured grid are available. Colors include: White, Tan, Champaign, Dark Bronze and Aluminum. You can also specify the grid pattern.

Insulating Glass Units (IG Units) can be made with air or other gases between the two sheets of glass. We use air-filled because the seals have a longer life with air. While we can provide Argon gas filled windows at an increased price, we caution that this could result in reduced life due to seal failure.

Capillary tubes are used in insulated glass in order to equalize pressure between the inside and the outside of the unit. During transit the insulated unit can travel the a variety of altitudes and the unequal pressure can weaken the seals, therefore shortening the life of the insulated unit. These tubes are to be removed prior to install and to be sealed with a silicon based sealant.